Avalue SENX-BYT Instrukcja Użytkownika Pobierz pdf (Strona 18)

SENX-BYT User’s Manual

18 SENX-BYT User’s Manual

2.3 Jumper and Connector List

You can configure your board to match the needs of your application by setting jumpers. A

jumper is the simplest kind of electric switch.

It consists of two metal pins and a small metal clip (often protected by a plastic cover) that

slides over the pins to connect them. To “close” a jumper you connect the pins with the clip.

To “open” a jumper you remove the clip. Sometimes a jumper will have three pins, labeled 1,

2, and 3. In this case, you would connect either two pins.

The jumper settings are schematically depicted in this manual as follows:

A pair of needle-nose pliers may be helpful when working with jumpers.

Connectors on the board are linked to external devices such as hard disk drives, a

keyboard, or floppy drives. In addition, the board has a number of jumpers that allow you to

configure your system to suit your application.

If you have any doubts about the best hardware configuration for your application, contact

your local distributor or sales representative before you make any changes.

The following tables list the function of each of the board’s jumpers and connectors.

Jumpers

Label

Function

Note

JPWR_LVDS1

LVDS VCC jumper

2 x 3 header, pitch 2.54 mm

JBAT2

Clear CMOS

1 x 2 header, pitch 2.00 mm

JME

ME update (For Flash BIOS use)

1 x 2 header, pitch 2.00 mm

Connectors

Label

Function

Note

F_PANEL1

Front Panel Switches

2 x 5 header, pitch 2.54 mm

MPCIE1

Mini-PCI-e connector

HDMI

HDMI connector

ATX_12V

DC in +12V DC Jack

JSPK

Speaker connector

1 x 4 wafer, pitch 2.00 mm

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 117 118

Komentarze do niniejszej Instrukcji

Brak uwag

Avalue SENX-BYT Instrukcja Użytkownika Strona 18

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Avalue SENX-BYT